一.标识/额定电压、频率、功率、色温等； Identification/rated voltage, frequency, power, color temperature, etc. 　　二.点灯试验/功能测试； Two. Point light test/function test; 　　三.耐压(绝绿強度)测试； Three. Withstand pressure (green strength) test; 　　四.连续性接地测试。 Four. Continuity ground test. 防触电保护分为： The protection of electric shock protection is divided into: 　　0类灯具：依靠基本绝缘作为防触电保护的灯具，此类国家严禁生产和出售； Class 0 lamps and lanterns: rely on the basic insulation as protection of the lamps and lanterns, such countries strictly prohibit production and sale; 　　I类灯具：灯具的防触电保护不仅依靠基本绝缘，而且还包括附加的安全措施，即易触及的导电部件连接到设施的固定布线中的保护接地导体上，使易触及的导电部件在万一基本绝缘失效时不致带电； I kind of lamps and lanterns of lamps and lanterns: not only rely on basic insulation protection against electric shock, but also includes additional security measures, namely the accessible conductive parts connected to the facilities of the protective earthing conductor in the fixed wiring, make accessible conductive parts of the basic insulation failure is not charged in the one thousand; 　　II类灯具：灯具的防触电保护不仅依靠基本绝缘，而且具有附加安全措施，例如双重绝缘或加强绝绿，没有保护接地或依赖安装条件的措施； Lamps and lanterns of lamps and lanterns of class II: not only rely on basic insulation protection against electric shock, and has the additional security measures, such as double insulation or reinforced off green, no grounding or depend on the installation conditions protection measures; 　　III类灯具：防触电保护依靠电源电压为安全特低电压，并且不会产生高于特低(SELV)电压的灯具。 Class III lamps: the protection of electric shock protection depends on the voltage of the power supply, and it will not produce the lamp that is higher than the low (SELV) voltage. 　　很多小工厂，是没什么安全意识，LED灯具能点亮即可。很多工程师说LED灯具，一打耐压就会损坏LED灯珠，这个认识是错误的，是非常不安全的。 A lot of small factories, there is no safety awareness, LED lamps can light up. A lot of engineers say LED lamps, a dozen withstand pressure can damage LED lamp bead, this knowledge is wrong, is very insecure.